Skip Navigation

Federal Communications Commission

English Display Options

Commission Document

Erratum - Proposed Amendments to the Service Rules et al.

Download Options

Released: May 1, 2013

Federal Communications Commission

Before the

Federal Communications Commission

Washington, D.C. 20554

In the Matter of
)
)
Proposed Amendments to the Service Rules
)
PS Docket No. 13-87
Governing Public Safety Narrowband Operations in )
the 769-775/799-805 MHz Bands
)
)
The Development of Operational, Technical and
)
WT Docket No. 96-86
Spectrum Requirements for Meeting Federal, State )
and Local Public Safety Communications
)
Requirements Through the Year 2010
)
)
National Public Safety Telecommunications
)
RM-11433
Council Petition for Rulemaking on Aircraft Voice )
Operations at 700 MHz
)
)
National Public Safety Telecommunications
)
RM-11433
Council Petition for Rulemaking to Revise 700
)
MHz Narrowband Channel Plan
)
)
Region 24 700 MHz Regional Planning
)
WT Docket No. 96-86
Committee Petition for Rulemaking
)
PS Docket No. 06-229
)
State of Louisiana Petition for Rulemaking
)
RM-11577

ERRATUM

Released: May 1, 2013

By the Chief, Public Safety and Homeland Security Bureau:
On April 1, 2013, the Commission released a Seventh Report and Order, FCC 13-40, in the
above-captioned proceeding. This Erratum amends the Seventh Report and Order as indicated below:
1.
Footnote 109 is corrected to read as follows:
See TIA-PRS October 2004 Ex Parte at 1-2, referencing (1) Project 25 FDMA Common
Air Interface, ANSI/TIA/EIA-102.BAAA-A-2003 (Revision A published September
2003); (2) Project 25 Vocoder Description ANSI/TIA/EIA-102.BABA-2003 (reaffirmed
December 2003); (3) Project 25 Data Overview-New Technology Standards Project-
Digital Radio Technical Standards ANSI/TIA/EIA-102.BAEA-A-2004 (revised June
2004); and (4) Project 25 Radio Management Protocol ANSI/TIA/EIA-102.BAEE-A-
2004 (renamed and revised June 2004 replacing Radio Control Protocol (RCP) - New
Technology Standards Project – Digital Radio Technical Standards ANSI/TIA/EIA-
102.BAEE-2000). Additionally, TIA-PRS updated the following standard after their
comments were filed: Project 25 Packet Data Specification, ANSI/TIA/EIA-102.BAEB-
A (adopted March 2005); Project 25 Radio Management Protocols—New Technology
Standards Project—Digital Radio Technical Standards, Telecommunications Industry

Federal Communications Commission

FCC 13-40

Association, ANSI/TIA/EIA-102.BAEE-B-2010 (adopted May 2010); Project 25 Data
Overview—New Technology Standards Project—Digital Radio Technical Standards,
Telecommunications Industry Association, ANSI/TIA/EIA-102.BAEA-B-2012 (adopted
June, 2012).”
2.
In Appendix C, under section 90.548(a), paragraph (2) is corrected to read as follows:
“(2) Transmitters designed for data transmission shall include a 12.5 kilohertz bandwidth
mode of operation conforming to the following standards, which are incorporated by
reference: Project 25 Data Overview—New Technology Standards Project—Digital
Radio Technical Standards, approved June, 2012, Telecommunications Industry
Association, ANSI/TIA/EIA-102.BAEA-B-2012; Project 25 Packet Data Specification—
New Technology Standards Project—Digital Radio Technical Standards, approved
March 2005, Telecommunications Industry Association, ANSI/TIA/EIA-102.BAEB-A-
2005; Project 25 Radio Management Protocols—New Technology Standards Project—
Digital Radio Technical Standards, approved May 2010, Telecommunications Industry
Association, ANSI/TIA/EIA-102.BAEE-B-2010; Project 25 FDMA—Common Air
Interface, approved September 2003, Telecommunications Industry Association,
ANSI/TIA/EIA-102.BAAA-A-2003.”
FEDERAL COMMUNICATIONS COMMISSION
David S. Turetsky
Chief, Public Safety and Homeland Security Bureau
2

Note: We are currently transitioning our documents into web compatible formats for easier reading. We have done our best to supply this content to you in a presentable form, but there may be some formatting issues while we improve the technology. The original version of the document is available as a PDF, Word Document, or as plain text.

close
FCC

You are leaving the FCC website

You are about to leave the FCC website and visit a third-party, non-governmental website that the FCC does not maintain or control. The FCC does not endorse any product or service, and is not responsible for, nor can it guarantee the validity or timeliness of the content on the page you are about to visit. Additionally, the privacy policies of this third-party page may differ from those of the FCC.