Skip Navigation

Federal Communications Commission

English Display Options

Commission Document

Uniden Granted Waiver to Allow Cordless Microphones for CB Radios

Download Options

Released: October 17, 2012
Federal Communications Commission
Washington, D.C. 20554
DA 12-1657
October 17, 2012
Gregg P. Skall
Counsel for Uniden America Corporation
Womble Carlyle Sandrige & Rice
1200 Nineteenth Street NW
Washington, DC 20036
Re: Uniden Request for Waiver of Section 95.419(a) of the Commission’s Rules
Dear Mr. Skall,
This letter grants the referenced request for waiver that you filed on behalf of Uniden America
Corporation on July 12, 2012 (hereinafter “Uniden Waiver Request”).1
Introduction. CB transceivers are used by the general public for short-distance personal and
business communications to and from both vehicles and fixed locations. In particular, CB transceivers
are still widely used by professional drivers in the long-haul trucking industry to communicate with the
drivers of other nearby trucks on the interstate highways. Operation of CB stations is authorized by rule;
the Commission does not issue an individual license for each CB station.2 CB transceivers are designed
to be directly operated by an individual located at the transmitter (local control). To this end,
Section 95.419(a) of the Commission’s rules prohibits operation of CB stations by radio remote control.3
Uniden’s waiver request. Uniden seeks a waiver of Section 95.419(a) as may be necessary to
allow manufacture, importation, certification and marketing of its newly-developed push-to-talk cordless
microphone for Uniden CB transceivers.4 As described in the request, the Uniden cordless microphone
operates under Part 15 Subpart D of the Commission’s rules in the Unlicensed PCS frequency band
(1920–1930 MHz) and employs the established Digital Enhanced Cordless Telecommunications (DECT)
protocols and technology that are used in that frequency band.5 Uniden argues inter alia that
Section 95.419(a) was adopted in 1983 to address the issue of remote operation of CB transmitters from
distant locations, and that preventing the use of cordless microphones, which have a very short range, was
neither contemplated nor intended. Uniden notes that the Commission has acknowledged that the use of


1 The Uniden Waiver Request is in the form of a July 5, 2012 letter to Julius P. Knapp (FCC Chief Engineer) and
may be viewed or downloaded from the Commission’s internet web page at:
http://apps.fcc.gov/ecfs/document/view?id=7021997165
2 47 C.F.R. §§ 95.403, 95.404; 47 U.S.C. § 307(e)
3 47 C.F.R. § 95.419(a). Remote control means operation of a station from a location other than the transmitter
location.
4 Uniden Waiver Request at 1– 3.
5 Uniden Waiver Request at 6. See http://en.wikipedia.org/wiki/Digital_Enhanced_Cordless_Telecommunications
last visited October 3, 2012.

2
cordless microphones and hands-free devices with CB transceivers installed in vehicles may be beneficial,
but thus far has not amended the CB rules to clearly allow such use.6
Precedent. In 2003, the Chief, Public Safety and Private Wireless Division, Wireless
Telecommunications Bureau (PSPWD) denied a request from Omnitronics, LLC (“Omnitronics”) for
waiver of the same rule, Section 95.419(a). The purpose of the Omnitronics request was to allow it to
produce an aftermarket CB cordless microphone that would work with other manufacturers’ CB radio
transceivers. Section 95.607 of the Commission’s rules, however, provides that only the holder of the
grant of authorization of a certified CB transmitter may make modifications to that transmitter, including
the addition of any accessory or device not specified in the original certification. Because Omnitronics’
proposed product was intended to be attached to CB transmitters for which it was not the holder of the
grants of equipment authorization, PSPWD held that Omnitronics was not eligible to seek a waiver of
Section 95.419(a). The PSPWD also stated that waiving Section 95.419 would undermine the rule and
the rule making process by inviting similar requests from other parties. In this regard, PSPWD noted that
Omnitronics had not filed a petition for rule making requesting that Section 95.419(a) be amended. For
these reasons, the PSPWD denied the waiver request and then subsequently upheld its denial on
reconsideration.7
Discussion. In general, we now believe that cordless microphones and hands-free devices used
with mobile telecommunications devices can provide important safety benefits to the public. Although
the particular Uniden product under consideration herein is a handheld speaker microphone, similar to a
standard corded CB microphone, it nevertheless offers some advantages that may promote safety in a
mobile environment. For example, as a cordless device, Uniden observes that it will not contribute to a
distracting or vision obstructing tangle of overhead cords in a truck cab where other communications
devices with microphones may also be in use.8 Also, a truck driver could carry the cordless microphone
outside the truck cab for a short distance and continue to communicate. We can easily envision the
situation where this capability would allow the driver of a truck stopped on a highway to leave the truck
cab and yet continue to communicate, warning other drivers of the potential hazard, while operating the
CB transceiver from a safe distance away from the stopped truck. Truck drivers often use their CB
transceivers to coordinate with individuals at loading docks, where the flexibility of out-of-cab CB
operation could improve the efficiency and safety of loading and unloading activities.
We agree with Uniden that Section 95.419(a) was adopted long before the technological
developments that make its cordless microphone possible, and not originally intended to prevent the use
of short-range cordless CB microphones using secure digital control link technology, like the Uniden
product. Section 95.419 today serves primarily to ensure that the responsible operator of a CB station is
located within the immediate vicinity of the transmitter9 and is able to maintain reliable control over the
CB transmitter.


6 Uniden Waiver Request at 2.
7 Order on Reconsideration, DA 03-3541, November 6, 2003.
8 Uniden Waiver Request at 7.
9 Because operation of CB transmitters is authorized by rule, pursuant to 47 U.S.C. 307(e), there is no FCC license
data file that provides the identity or location of the operator of any CB transmitter. An operating CB transmitter
itself can usually be located by the FCC using radio direction finding methods. To find or identify the responsible
operator of a CB station concerning operation of that station, it is helpful if the operator is located in the immediate
vicinity of the CB transmitter, rather than a distant remote control location. Section 95.419(c), applicable to direct
mechanical or wired control of CB transmitters, provides some guidance in this regard – that locations on the same
premises, craft or vehicle are not considered to be remote control.

3
Uniden’s cordless CB microphone is proposed to operate with a transmit power of 17 dBm.10
This low power level limits the usable range of the Uniden cordless microphone to 30 meters
(approximately 100 feet).11 Consequently, a CB operator using the Uniden cordless microphone will be
located in the immediate vicinity of the CB transmitter.
Furthermore, the DECT technology proposed for use by Uniden incorporates an industry-standard
secure method of signal encoding ensuring that the Uniden cordless microphone will allow the operator to
maintain reliable control over the CB transmitter. The use of digital codes from a universe of 130,000
possible codes12 ensures that the Uniden cordless microphone will not accidentally or intentionally control
any CB transceiver other than the one with which it is associated. Furthermore, the DECT “listen before
transmit” spectrum sharing protocol will ensure that no DECT device operating in the Unlicensed PCS
band will block the Uniden microphone, nor vice versa. The Uniden cordless microphone is designed to
automatically end transmission from the CB transceiver within 3.2 seconds in the event the cordless link
were to be interrupted for any reason, so that a continuous transmit situation due to loss of the control link
cannot occur.
We find that this case is distinguishable from the 2003 PSPWD decision in the Omnitronics case.
First, because the Uniden cordless microphone is designed to be used with Uniden CB transceivers, its
proposal, unlike that of Omnitronics, complies with Section 95.607 of the Commission’s rules. Uniden
would be the grantee of the equipment authorization for both the cordless microphone and the CB
transmitter(s) with which it is intended to be used. Furthermore, the rulemaking process is not
circumvented by the Uniden request, because the Commission has already proposed to amend the rules to
allow cordless microphones and hands-free headsets to be used with CB radios, in pending WT Docket
No. 10-119.13 Comments filed in that proceeding thus far generally support such use. Finally, although
our action herein may result in similar requests from other CB transceiver manufacturers, we believe that,
in view of the relatively small number of CB transceiver manufacturers today, the number of such
requests will be limited. We therefore find that the public benefits of allowing the use of the Uniden
cordless microphone product outweigh the potential administrative cost of addressing any such similar
waiver requests that may be filed.
In summary, we find that a strict application of Section 95.419(a) in the instant case preventing
the use (and consequently, manufacture, certification and marketing) of the proposed Uniden cordless
microphone would not serve the purposes of the rule. We further find, in view of the foregoing
discussion, that grant of the requested waiver is in the public interest.14


10 Uniden Waiver Request at 8. Uniden intends to set the transmit power to a level of ½ to ¼ of the DECT limit, in
order to provide longer battery life. This transmit power level is about the same as that of a PCS telephone
operating in the adjacent licensed PCS bands.
11 See Uniden supplementary letter, which may be viewed from the Commission’s internet web page at:
http://apps.fcc.gov/ecfs/document/view?id=7022027628
12 Uniden Waiver Request at 5.
13 See Notice of Proposed Rule Making and Memorandum Opinion and Order on Reconsideration (NPRM),
FCC 10-106, 25 FCC Rcd 7651, 75 Fed. Reg. 43423 and 47142, released June 7, 2010 at ¶ 53.
14 See 47 C.F.R. § 1.925(b)(3)(i).

4
Ordering Clause. Accordingly, effective on the date of this letter, Uniden’s request for a waiver
of Section 95.419(a) to allow use (and thus manufacture, certification, importation and marketing) of the
cordless microphone as described in the instant Uniden waiver request is GRANTED conditioned on the
outcome of the related rulemaking proceeding discussed above. This action is taken under delegated
authority pursuant to Sections 0.131 and 0.331 of the Commission’s Rules, 47 C.F.R. §§ 0.131, 0.331.
FEDERAL COMMUNICATIONS COMMISSION
Roger Noel
Chief, Mobility Division
Wireless Telecommunication Bureau

Note: We are currently transitioning our documents into web compatible formats for easier reading. We have done our best to supply this content to you in a presentable form, but there may be some formatting issues while we improve the technology. The original version of the document is available as a PDF, Word Document, or as plain text.

close
FCC

You are leaving the FCC website

You are about to leave the FCC website and visit a third-party, non-governmental website that the FCC does not maintain or control. The FCC does not endorse any product or service, and is not responsible for, nor can it guarantee the validity or timeliness of the content on the page you are about to visit. Additionally, the privacy policies of this third-party page may differ from those of the FCC.