Skip Navigation

Federal Communications Commission

English Display Options

Figure 8, Section 73.190 for AM Broadcast Stations

Broadcast engineers can perform calculations here of the theoretical inverse distance field strengths in the vicinity of AM broadcast radio stations, using the graphs in Figure 8, Section 73.190 of the FCC's rules.  Calculations will be made of the theoretical field strength generated by the AM station at a distance of 1 kilometer (or one mile if English units are selected) at the specified effective radiated power (ERP).  The analysis will also return the theoretical field strength using a reference ERP of 1 kW.  Calculations may be made in metric or English units, or in electrical degrees (360 electrical degrees = 1 wavelength). 

Figure 8, Section 73.190 Calculations

Frequency between 530 and 1700 kHz: 

Measurement Units: 


Purpose of Figure 8

The inverse distance field is the electric field strength generated by the AM station at the assigned station frequency.  The units of electric field strength used here are millivolts per meter (mV/m).  Field strength diminishes with increasing distance from the AM station (hence the "inverse" relationship of field strength to distance).

Figure 8 of Section 73.190 is used by broadcast engineers to determine whether a proposed or modified facility will meet the Commission's AM station minimum efficiency requirements (see 47 CFR Section 73.189 and Figure 7, 47 CFR Section 73.190), prior to conducting actual measurements of field strength.  It also serves as a basis against which measurement data can be compared.  Users are cautioned that this program does NOT determine whether a particular result meets the Commission's minimum efficiency requirements (refer to Section 73.45 and Section 73.189(b)).  Applications for AM broadcast stations that do not meet the minimum efficiency requirements generally will not be accepted.

Measurements of the inverse distance field are used to determine the circularity of nondirectional AM stations as well as directional AM stations operating in nondirectional mode (only one tower operating).  If the measurements show a consistent field strength at a given distance at all angles from the tower, then the AM pattern is circular.  For directional stations, comparison of measurements made in directional mode can be compared to measurements taken during nondirectional operation.  Because the "close in" measurements (which are taken within 3 km of the transmitter site) are minimally affected by changes in ground conductivity or seasonal variations, this comparison will show the actual directional pattern generated from the two or more towers comprising the AM directional antenna array.

Figures 7 and 8 Graphs, Section 73.190

The graphs contained in 47 CFR 73.190, including Figure 7 (minimum vertical height of AM broadcast station antennas) and Figure 8 (effective field at 1 km for 1 kW) can be obtained by retrieving the PDF version of Section 73.190 (includes several graphs).  Alternatively, you can retrieve enlarged versions of Figures 7 and 8 as GIF images to your browser:

Note on Figure 8 results for nondirectional AM stations:  Where the average length of the ground system radials is less than 1/4 wavelength, or if the number of ground radials is more than 90 but less than 120, this program will apply the appropriate correction factors and calculate the corrected theoretical field strengths.

Information about AM broadcast radio stations is available at the Audio Division on the FCC's website, and at Broadcast Radio Links

FCC > Media Bureau > Audio Division

Reviewed: November 4, 2014

You are leaving the FCC website

You are about to leave the FCC website and visit a third-party, non-governmental website that the FCC does not maintain or control. The FCC does not endorse any product or service, and is not responsible for, nor can it guarantee the validity or timeliness of the content on the page you are about to visit. Additionally, the privacy policies of this third-party page may differ from those of the FCC.